What to do if Harbor Breeze 40016 does not move?
If your Harbor Breeze Fan isn't moving, consider these potential causes: * Reverse switch not engaged: Push the switch firmly either to the 'Left' or 'Right'. * Wall switch is off: Ensure the wall switch is turned on. * Power issue: Turn the power on or check the fuse (breaker). * Wiring problem: Turn the power off and check all connections at the ceiling outlet box.
What to do if Harbor Breeze 40016 Fan lights fail?
If your Harbor Breeze Fan is operating but the lights are not working, check the following: * Bulb installation: Re-install the bulb(s) to ensure they are correctly fitted. * Light kit wire plugs: Make sure the male and female plugs in the light kit fitter are connected properly. * Wiring: Turn the power off and check all connections at the ceiling outlet box. * Wattage: The fan has a 190W limiter. If the total wattage of the lights exceeds 190W, the light will turn off. Replace with bulbs of lower wattage.
How to fix Harbor Breeze 40016 Fan wobbling?
Excessive wobbling in your Harbor Breeze Fan can be due to several factors: * Loose blades: Check and tighten all screws that hold the fan blades to the blade arms and the blade arms to the motor. * Unbalanced blades: Try switching one blade with a blade from the opposite side or use a balancing kit (not supplied) to balance the fan. * Insecure fan mounting: Turn off the power, loosen the canopy, and verify that the mounting bracket is securely attached to the electrical outlet box. The bracket must be flush against the outlet box without any movement. * Fan too close to vaulted ceiling: Use a longer down rod or move the fan to another location. * Loose set screw: Lift up the yoke cover and tighten the set screw to the yoke until secure.
Why is my Harbor Breeze Fan so noisy?
There are several reasons why your Harbor Breeze Fan might be noisy: * Blades are loose: Check and tighten all screws that hold fan blades to blade arms and motor. * Cracked blade/blades: Replace any cracked blades. * Non-compatible wall control: Avoid using a full range dimmer switch to control fan speed. * Break in period: Run the fan continuously on medium or high speed for 24-48 hours for the 'break in' period. * Outlet box is not secured: Ensure the outlet box is securely attached to the building structure. * Mounting bracket is not secured: Verify the mounting bracket is secured to the outlet box and that all screws are tight.
Wiring instructions for fan and light controlled via pull chains.
Wiring for fan via pull chain and light via separate wall switch.
Wiring for fan and light using independent wall switches.
General| Brand | Harbor Breeze |
|---|---|
| Model | 40016 |
| Type | Ceiling Fan |
| Number of Blades | 5 |
| Control Method | Pull chain |
| Mounting Type | Downrod |
| Reversible Motor | Yes |
| Indoor/Outdoor Use | Indoor |
| Blade Span | 52 inches |
| Motor Type | AC Motor |
To Next Page