10
Adjustment of the operating unit
1. Open or close lever 4 depending on whether pressure agitation is
required. (Remember pressure agitation takes 5% to 10% of pump
output).
2. Turn main on/off handle 2 to spraying position A.
3. Set all hand levers 3 on the distribution valve to spraying position A.
4. Turn the HARDI-MATIC valve 6 anti-clockwise to its extreme position.
5. Turn the safety valve 1 clockwise to maximum pressure.
6. Put the tractor in neutral and set the engine revolutions and thereby
the number of revolutions of the pump corresponding to the intended
travelling speed. Remember the number of revolutions on the P.T.O.
must be kept between 300-600 r/min.
To Next Page
Loading...
