6
It is important for the personal
safety of the operator that the
transmission shaft is intact.
The protection guards must
cover the whole shaft. This
includes the universal cross
covers at each end of the
shaft. The chains are con-
nected so that the protection
guards do not rotate with the
shaft.
To ensure long life of the
transmission shaft, try to avoid
working angles greater than 15°.
Hydraulics
Hydraulic connection necessitates one single acting outlet. The system
will require a capacity of approx. 2 litres and a minimum pressure of
100 bar.
WARNING
INITIAL RAISING AND LOWERING SHOULD BE DONE CAU-
TIOUSLY; THERE MAY BE A LITTLE AIR IN THE SYSTEM
AND THIS MAY CAUSE ERRATIC MOVEMENTS. THERE-
FORE TAKE CARE THAT NO PERSONS OR OBJECTS ARE
HURT OR DAMAGED IN THE PROCESS OF TESTING.
Rear lights (if fitted)
Connect plug for rear lights to the tractors 7-poled socket and check
that rear lights, stop lights and turning indicators work properly before
driving anywhere.
Roadworthyness
When driving on public roads and other areas where the highway code
applies, or areas where there are special rules and regulations for
marking and lights on implements, you should observe these and
equip implements accordingly.
To Next Page
Loading...
Need help?
General
