Example: T
o use the Video 4 button to operate
a satellite receiver
, first press the
Video 4 Input
Selector
e and the Mute Button at the
same time until the red light glows under the
Video
4 Button
e. Press the VID2/SAT Button e,
followed by the three-digit code for the specific
model you wish to control. Finally, press the
Video 4 Button e again.
Resetting the Remote Memory
As you add components to your home theater system,
occasionally you may wish to totally reprogram the
remote control without the confusion of any commands,
macros or “Punch-Through” programming that you may
have done. To do this, it is possible to reset the remote
to the original factory defaults and command codes by
following these steps. However, once the remote is
reset, all commands or codes that you have entered will
be erased and will need to be reentered:
1. Press any of the
Input Selector Buttons e and
the
“O” Button r at the same time until the
Program Indicator c begins to flash amber.
2. Press the
“3” Button r three times.
3. The red LED under the
Input Selector e will go
out and the
Program Indicator c will stop flash-
ing and turn green.
4. The
Program Indicator c will remain green until
the remote is reset. Note that this may take a while,
depending on how many commands are in the
memory that need to be erased.
5. When the
Program Indicator c goes out, the
remote has been reset to the factory settings.
33
34
35
36
37
38
39
40
41
4
8
49
4
6
47
4
4
45
4
2
43
38
39
4
0
41
3
1
32
30
28
2
9
25
26
27
2
8
29
30
24
23
2
2
21
20
31
37
36
3
5
34
33
32
31
37
3
6
35
34
33
32
48
49
5
0
51
47
4
6
45
44
43
42
40 PROGRAMMING THE REMOTE
PROGRAMMING THE REMOTE
To Next Page
Loading...
Need help?
General
