Harman Kardon AVR1700 User Manual

SAFETY PRECAUTIONS
The following check should be performed for the continued
protection of the customer and service technician.
LEAKAGE CURRENT CHECK
Measure leakage current to a known earth ground (water
pipe, conduit, etc.) by connecting a leakage current tester
between the earth ground and all exposed metal parts of the
appliance (input/output terminals, screwheads, metal
overlays, control shaft, etc.). Plug the AC line cord of the
appliance directly into a 120V AC 60Hz outlet and turn the
AC power switch on. Any current measured must not exceed
o.5mA.
ANY MEASUREMENTS NOT WITHIN THE LIMITS
OUTLINED ABOVE ARE INDICATIVE OF A
POTENTIAL SHOCK HAZARD AND MUST BE
CORRECTED BEFORE RETURNING THE APPLIANCE
TO THE CUSTOMER.
Device
under
test
Test all
exposed metal
surfaces
Also test with
plug reversed
(Using AC adapter
plug as required)
AC Leakage Test
Leakage
current
tester
Reading should
not be above
0.5mA
Earth
ground
AVR1700 harman/kardon
3

Harman Kardon AVR1700 Specifications

General

Number of Channels	5.1
HDMI Inputs	6
HDMI Outputs	1
USB Input	Yes
Dolby Digital	Yes
DTS	Yes
Input Sensitivity/Impedance	200mV/47k Ohms
Signal-to-Noise Ratio (IHF-A)	100 dB
FM Tuner Frequency Range	87.5 MHz – 108.0 MHz
FM Tuner Signal-to-Noise Ratio (Mono/Stereo)	70 dB/68 dB
FM Tuner Distortion (Mono/Stereo)	0.2%/0.3%
FM Tuner Stereo Separation	40 dB @ 1 kHz
AM Tuner Distortion	1.0%
HDMI	Yes
HDMI Audio Return Channel	Yes
Bluetooth	No
Wi-Fi	No
Power Output per Channel	100W
Weight	5.1kg
FM Tuner Usable Sensitivity (IHF)	1.3 μV/13.2 dBf
AM Tuner Frequency Range	530-1710kHz
AM Tuner Usable Sensitivity (Loop)	500 μV/m
Power Requirement	120V, 60Hz
Stereo Mode Power	100 watts per channel