After selecting a product from the list, the
product’s icon will appear in the middle of the
screen, along with its Wi-Fi signal strength. After
confirming you have selected the correct product,
select ‘Done’ in the top-right corner of the screen.
Take note of the Wi-Fi signal strength. If it appears
low, you may need to consider moving the
product closer to your Wi-Fi router, or expanding
your Wi-Fi network. After moving the product
closer to your Wi-Fi network, remember to press
the ‘Refresh signal strength’ button to check if
the signal strength has increased.
Note: We recommend operating with at least two
bars of signal strength. Low signal strength may
impact performance.
After selecting a room type, a list of available
products will be displayed at the bottom of the
screen. To set up a ‘Stand alone’ room, select one
of these products.
Note: If at any point your speaker loses its
connection to the network go through the steps
previously shown and tap the ‘Refresh signal
strength’ button in the upper left-hand corner.
ROOM SETUP
28
To Next Page
Loading...
