12
BUTTONS AND CONNECTORS
WPS Button
This button is used to connect the speaker to your home Wi-Fi network. Press it to enter WPS PBC mode.
Press it for 5 seconds to enter WPS PIN mode. See the WPS section on page 15 for more information.
Reset Button
Press the Reset button for 5 seconds to perform a factory reset. This will erase all user settings,
disconnect from the Wi-Fi network, and the speaker will enter Wi-Fi setup mode, allowing you to
connect it to a different Wi-Fi network.
AC Power Connector
Use the supplied power supply (Omni 10+) or power cord (Omni 20+) to connect the speaker to AC
power.
Audio In Connector
Connect an analog audio source via a 3.5mm or 1/8” stereo AUX cable to this connector to enjoy
audio from an analog audio device.
Ethernet Connector
You may optionally connect an Ethernet cable to this port for a faster, more stable network connec-
tion. It’s possible to connect some speakers via Wi-Fi and others via Ethernet, if desired.
To Next Page
Loading...
