15
If you are only using one Omni 10+ or one Omni 20+ in this room, the room setup is complete. You
may now set up additional rooms through the same process, or start streaming music. If you’re
setting up a stereo pair, the Controller app will guide you through this process one more time, then
proceed to Stereo Pair Setup on page 16.
Android
You will now see each Omni 10+ or Omni 20+ speaker you have connected to AC
power on the screen. Select any one of the speakers to see a list of available Wi-Fi
networks. Choose the Wi-Fi network you wish to connect your Omni+ speakers
to, then enter the Wi-Fi password. Every Omni+ speaker will reboot and connect
to this Wi-Fi network.
Note: If you don’t see the correct Wi-Fi network, make sure that the speaker is in range of the Wi-Fi
router or access point.
If you are only using one Omni 10+ or one Omni 20+ in this room, the room setup is complete. You
may now set up additional rooms through the same process, or start streaming music. If you’re
setting up a stereo pair, proceed to Stereo Pair Setup on page 16.
WPS
WPS is a simple way to connect your system to your home Wi-Fi network. To confirm whether your
router supports WPS, look for the WPS logo or the letters WPS on your router. The Omni 10+ and
Omni 20+ support both WPS-PBC and WPS-PIN modes.
WPS-PBC
To connect your speaker via WPS-PBC mode:
1. Press the WPS button on your Wi-Fi router or access point.
2. Within one minute, press the WPS button on the bottom of your Omni 10+
or Omni 20+.
3. The Link button on the top of the speaker will begin to quickly flash for up to
one minute. When the LED stops flashing and turns solid white, your speaker
is connected.
Note: This will connect your speaker to the network. After this is complete, you must open the
Harman Kardon Controller app and set up a new room for this speaker.
SPEAKER SETUP
SSID
PASSWORD
To Next Page
Loading...
