Harman Absolute 43 - Specific Component Maintenance; Burnpot Maintenance

Harman® • Absolute43 Owner’s Manual_R2 • 2015 -___ • 03/1511
3-90-777000c
Weekly or when adding fuel,taketheopportunitytoclean
the burn pot. (Weekly at minimum)
• Pull the ame enhancer forward to access the grate
surfaceandpullanyashesfrominfrontofthereusing
the burn pot scraper allowing it into the ash pan.
• Scrapethegrate surfacedownward,towardtheauger.
Figure2.1.Anycarbondepositsloosenedatthistimewill
be pushed out as new fuel is fed in.
Monthly, or after each ton of fuel burned:
Afterburningapproximately1tonofpellets,amorethorough
cleaningisrequiredtokeepyourstoverunningefciently.
Whenthestovehascompletelycooledandstoppedrunning,
it’snowsafetoclean.
• Shutdownthestove.
• Unplugthepowercordfromtheoutlet.
• Pulluponcoverhandletogainaccesstoigniterelement
andcradle.Figure2.2.
• Usingthebrushsupplied,brushtheigniterelementfree
ofanyashordebris.Figure2.2.
Theburnpotgratecanberemovedifneeded.Figure2.3.
• Remove the flame Enhancer by pulling straight up
removing tabs from burn pot sides.
• Removethe(2)1/2”allenheadboltsfromeachsideof
the burn pot.
• Slidethegratetowardyoutoremove.
NOTE: the grate does not need to be removed to
properlycleantheigniter.Thispartisremovableforpart(s)
replacement only.
C. Burnpot Maintenance
Disconnect the power to the unit before removing
cover.
DANGeR
!
Figure 2.2
Viewed from below through the ash pan opening.
Igniter Cradle
Pull up on the cover handle to
gain access to the igniter
Figure 2.1
Flame Enhancer
Remove Flame Enhancer
Figure 2.3
Brush ash and debris from
Igniter Element.
Igniter Cradle and Element
When cleaning burn pot clean-out chamber. Do not
damage the high temperature igniter wires.
CAUTION
!
(2) 1/2” Allen head bolts