Need help?Do you have a question about the Harman dbx ZonePRO 640 and is the answer not in the manual?
General| Input Channels | 6 |
|---|---|
| Output Channels | 4 |
| Crossover | Yes |
| Delay | Yes |
| Compressor | Yes |
| Noise Gate | Yes |
| Frequency Response | 20Hz - 20kHz |
| Dynamic Range | >110dB |
| Power Supply | 100-240 VAC 50/60Hz |
| Control Interface | Ethernet |
| Audio Processing | EQ, Crossover, Delay, Compressor, Noise Gate, Level Control |
Guide to connecting ZonePRO devices via RS-232 and initial setup steps.
Steps for configuring Ethernet networking and establishing an online connection.
Guidelines for wiring Zone Controllers in series or parallel, including cable specs and lengths.
Steps to associate volume and source selection controllers with specific inputs or outputs.
Step-by-step guide for connecting ZonePRO directly to a PC via Ethernet crossover cable.
Instructions for setting up a simple, isolated Ethernet network with ZonePRO devices.
Information on VPNs, network considerations, limitations, and troubleshooting common issues.
Example setup and configuration notes for a restaurant audio system using ZonePRO.
To Next Page