10
CPi2000 Cinema Processor
User Guide
•
5.1/7.1 INPUT
The 5.1/7.1 INPUT screen is where the input source processing can be selected. The default setting is 5.1 input.
Please note, if the unit is set to 5.1 input, BLS and BRS will copy audio signals from LS and RS respectively.
5.1/7.1 INPUT Screen
•
FAULT DETECTION
The FAULT DETECTION screen shows the fault detected by scrolling the information through the screen.
FAULT DETECTION Screen
•
USB
The USB screen is used to load a preset from or save a preset to a USB device connected to the USB connector
(6 @ rear panel). This is helpful when copying the device settings to another CPi2000 or preparing for system
upgrading.
USB Screen
•
RETURN TO PANEL
RETURN TO PANEL shows the current firmware version of the CPi2000. When the RETURN TO PANEL screen
is shown through the LCD display, press the Volume/Edit Encoder (9 @ front panel), then the LCD will navigate
back to the home screen.
To Next Page
Loading...
