Harman JBL-R4500 - Page 13

Bluetooth Section Operation
3. Pair BT Device
In Bluetooth source, pick "A4500" option on your Bluetooth enabled device .
(if you are prompted for a password, the code entered will be " 0000 or 1234" .)
Note : The Bluetooth pairing only happens with unit in Bluetooth mode .
4. Play/Pause Play
Once the BT device being paired is successful, music will begin to play .
Note: For some Bluetooth enabled phones, you may need to activate play from your phone
first. It depends on the phone itself.
While BT Music is playing , press the PAUSE button to pause the playback , and press it again
to resume playback .
Note: 11 refers to PAUSE; ► refers to PLAY .
5. Disconnect
In BT Music playing mode , in order to disconnect
the BT device , press MENU to display Bluetooth
Settings, turn VOL knob and press it at Disconnect.
Note: When your BT device battery is at low charge,
the Bluetooth connection may occasionally be
lost . To maintain good connectivity ensure that
your BT device battery is adequately charged .
6. Connect
Wi th BT turned to on from your music device, but disconnected from the JBL-R4500 , to
re -establish BT connection press MENU to di splay BT settings. Turn knob and press it at
Connect .
Note: With the Bluetooth connection disconnected , once you power on the unit next time ,
you should go into Bluetooth mode , then it will establish the Bluetooth connection
automatically . Sometimes, with Bluetooth mode not in use for over 1 hour , when you
switch to BT mode again , it might take some time (5- l0s) to re-establish the connection
by itself .
12