Harman JBL-R4500 - Troubleshooting

Troubleshooting
*Note : In many respects, a stereo acts much li ke a compute r and occasionally requires a reboot.
In the unlik ely event of product malfunction, a reset can usually fix the issue.
Reset: Press and hold MENU knob ove r 3s to display SETUP, or turn VOL knob at Ho me Screen
and push SEL at SETUP. Then turn VOL knob and push it at ABOUT . It will display firmware
infor mati on on the screen; press and hold SEL knob for about Ss until Facto ry Reset appears
on the display screen, then select [YES] and press SEL knob to confirm yo ur selection.
ISSUE CAUSE SOLUTION
No power
1. Incorrect wiring
1. Double check wiring.
2. Fuse is blown 2. Replace fuse
3. Low battery voltage 3. Check voltage of vehicle battery
with multimeter . Voltage must be at
least 11V .
No Sound 1. Speaker connection
1.
Double check connections.
came loose 2. Replace bad speaker with known
2. Bad speaker good speaker and connect.
3. Output blown
3. Send unit in for repair .
4. Volume too low 4. Increase volume of media device
No Reception 1. Antenna not firmly seated
1. Insert firmly
in socket .
USB stick not
1.
File must be a mp3 1. Convert format to mp3 or wma .
reading orwmafile
Wh ile in Bluetooth mode :
No Connection 1. You ore not connected
1. Choose "R4500"
to the " R4500 " address on 2. Bring portable med ia dev i ce closer
your portable media
to the receiver. Device needs to be
device. within 30 '.
2. Out of range 3. Ask your booting buddy who is
3. The connection is curr ently connec ted to disconnect.
already in use.
18