Harman Martin MAC Aura XIP User Manual

48 MAC Aura XIP User Manual
*The TEMPERATURES, DMX LIVE, MANUAL CONTROL and SERVICE menus are not available when the fixture is operating
on battery power.
SERVICE*
(see “Activating
service mode” on
page 12)
ERROR LIST Empty or up to 20 errors
Show all error and warning messages
stored in memory.
FAN CLEAN ON/OFF
Run cooling fans at high speed to dislodge
dust and debris.
PAN/T ILT
FEEDBACK
ON
Enable pan/tilt position feedback
system
OFF Disable pan/tilt position feedback system
ADJUST
(for use by or with
guidance from
Martin Service
only)
PAN/TILT AT END
STOP
STEP 1
To adjust, move head to end position and
press ENTER
STEP 2
To adjust, move head to end position again
and press ENTER
CALIBRATION
BEAM DIMMER
...
AURA BLUE
Calibration range
varies depending
on effect
Scroll through effects, press ENTER to
select. Adjust position and press ENTER
to confirm.
LOAD DEFAULTS LOAD Load factory default calibration settings
SAVE DEFAULTS SAVE
Replace factory default calibration settings
with current calibration settings
EMPTY WATER START
ARE YOU SURE?
→ YES/NO
Fixture dims and tilts head to drain any
water buildup from front lens
DRY OFF START
ARE YOU SURE?
→ YES/NO
Activate drying off function
SAFE PARKING ENABLE
ARE YOU SURE?
→ YES/NO
Moves head to position where rain / snow
cannot accumulate on front lens.
SERVICE
(continued)
USB
NO DEVICE
No USB memory device detected at USB
port or no firmware detected on USB
memory device
UPDATING FILES
Fixture updating internal memory from
USB memory device
AVAILABLE
FIRMWARE
XX.XX.XX ...
XX.XX.XX
Select firmware from versions stored in
internal memory. Scroll to select version,
then press ENTER and confirm your
choice to update.
Menu level 1 Menu level 2 Menu level 3 Menu level 4 Notes (Default settings in bold print)
Table 4: Control menus

Harman Martin MAC Aura XIP Specifications

General

Brand	Harman
Model	Martin MAC Aura XIP
Category	Flood Light
Language	English