Service and display messages
51
SEER SACN SOURCES EXCEEDED Number of sACN control sources exceeded.
SLER SAFETY LOOP
Safety loop circuit activated. A temperature circuit breaker has shut
down LEDs. Circuit breaker resets automatically after temperature
has returned to normal operating range.
TSER TILT SENSOR ERROR Fixture unable to retrieve data from Tilt position sensor.
UELD UPL ERR LED DRV
Could not upload new LED driver software during a firmware
upload. Error cleared when new firmware is uploaded successfully
or power is cycled off and on.
UEPT UPL ERR PAN/TILT
Could not upload new pan/tilt system software during a firmware
upload. Error cleared when new firmware is uploaded successfully
or power is cycled off and on.
UITC UI TEMP CUTOFF
User interface (LCD display and control panel) temperature cutoff
activated.
UITE UI TEMP SEN ERR
User interface (LCD display and control panel) temperature sensor
error.
ZOER ZOOM ERROR Zoom car position error.
Short code Long message Explanation
Table 6: Error messages
To Next Page
Loading...
Need help?
General