Harman P43 - Fuel Specifications

Harman® • P-Series Installation Manual_R3 • 2014 -___ • 09/1410 3-90-436168i
Figure 3.3
P43-Minimumsizerectangularoorprotection(USA)is32
1/2
"wideBy33"deep(825mmX838mm).
P61A-Minimumsizerectangularoorprotection(USA)is28
5/16
”DeepBy24
3/4
”Wide(719mmX629mm).
P68-Minimumsizerectangularoorprotection(USA)is33”DeepBy25”Wide(838mmX635mm).
*FloorprotectiondimensionsforthefrontandsidesaremeasuredfromtheappliancedooropeninginTheUnitedStates.In
Canada,thesidedimensionismeasuredfromthewidestpartoftheappliance.
NOTE:Measurement"L"ismeasuredfrom
thepedestalbaseintheUSONLY
NOTE:Measurement“K”ismeasuredfrom
theglassintheUSONLY
L
J
Floor Protection
Requirements
US
Canada
Sides
Rear
6" 200mm
6" 200mm
K
Front
6" 450mm
J
USA
K
L
J
CANADA
Floor protector
C. Floor Protection
Place the stove on a noncombustible type oor or oor
protectorthatextendsaminimumof6inches(152mm)tothe
frontoftheloaddooropening,6inches(152mm)tothesides
ofthedooropening,and6inchestotherear.Floorprotection
mustalsoextend2inches(51mm)beyondeachsideofany
horizontal ue pipe. The minimum oor protector material
is20gaugesheetmetal.Otheroorprotectormaterialsare
ceramictile,stone,brick,etc.Figure3.3
NOTE for Canadian installation only:PerULC-S627-00,
If installed on a combustible oor, the need to provide a
noncombustible oor protector covering the area beneath
thespaceheaterandextendingatleast17.72”(450mm)on
theringsideandatleast7.87”(200mm)ontheothersides.
In Canada, you may follow smaller U.S. oor protection
requirements ONLY if the user agrees to completely
shut-down the appliance, and allow it to cool to where
all re is extinguished and the combustion blower and
its indicator light shuts off, prior to opening the rebox
door or ash door.
D. Mobile Home Installation
When installing this unit in a mobile home, several
requirementsmustbefollowed:
1. Theunitmustbeboltedtotheoor.Thiscanbedonewith
1/4”lagscrewsthroughthe2holesinthebaseplate.
2. Theunitmustalsobeconnectedtooutsideair.Seesection
4-DOutsideAir.
3. Floor protection and clearances must be followed as
shown.
4. Unitmustbegroundedtothemetalframeofthemobile
home.
P43 = 42-5/8”
P61A/P68 = 50”
Corner to edge dimension for corner installation oor protection.