Harman P43 Owner's Manual

Harman® • P-Series Owner’s Manual_R1 • 03/1422 3-90-436168c
Feeder Chamber
This chamber may get a buildup of nes from the feeder
mechanismmovement.Thisarea should bechecked and
cleanedatleastonceayear.
To remove the feeder cover:
• Loosenthe5/16"wingnut.Figure5.8.
• Liftupandslidethecoveroffofthethreadedstud.
• InspectandcleantheinnerchamberifnecessaryFigure
5.9.
• Reinstallthecovermakingcertainitisseatedproperlyon
thefeederbodyandtightenastightlyasyoucanbyhand.
NOTE: Views are shown with the rear motor covers
removed.
Pellet Metering
Slide Plate
Possible pellet nes
buildup area.
Figure 5.9
5/16" Wing NutFeeder clean out cover
Figure 5.8
G. Pellet Feeder Chamber

Harman P43 Specifications

General

Fuel Type	Pellet
Ignition	Automatic
Thermostat	Yes
Heating Area	Up to 2, 200 sq ft
Blower	Yes
Warranty	Limited