Harman P43 - General Operating Information

Harman® • P-Series Owner’s Manual_R1 • 03/1411 3-90-436168c
E. Before Your First Fire
1. Makesureyourappliancehasbeenproperlyinstalledand
thatallsafetyrequirementshavebeenmet.Payparticular
attentiontothereprotectionandventinginstructions.
2. Doublecheckthattheashpanandreboxareempty!
3. Closethefrontdoor.
FireHazard.
Keepcombustiblematerials,gasoline
andotherammablevaporsandliquids
clearofappliance.
E. General Operating Information
1. Room Sensor Calls For Heat
Theapplianceislikemostmodernfurnaces;whentheroom
sensorcallsforheat,yourappliancewill automaticallylight
anddeliverheat.
Whentheroomisuptotemperatureandtheroomsensoris
satised,theappliancewillshutdown.
2. Heat Output Controls
The appliance will turn on and off as the room sensor
demands.Whentheroomsensorcallsforheat,theappliance
willalwaysstartuponHigh.Afterburningapproximately7-10
minutes,theappliancewillthenburnattherateatwhichit
wasoriginallyset.Iftheapplianceissetatoneofthelower
settings,itwillrunquieterbuttakelongertoheatupanarea
thanifitweresetatahigherburnrate.
Regardlessoftheburnrate,whentheareaiswarmenough
tosatisfytheroomsensor,theappliancewillshutoff.
WARNING
!
• DoNOTstoreammablematerialsintheappliance’svicinity.
• NEVER USE GASOLINE, GASOLINE-TYPE LANTERN
FUEL, KEROSENE, CHARCOAL LIGHTER FLUID, OR
SIMILARLIQUIDSTOSTARTOR“FRESHENUP”AFIRE
INTHISHEATER.KEEPALLSUCHLIQUIDSWELLAWAY
FROMTHEHEATERWHILEITISINUSE.
• DONOTBURNGARBAGEORFLAMMABLEFLUIDSSUCH
ASGASOLINE,NAPHTHAORENGINEOIL.
• DONOTUSECHEMICALSOF FLUIDSTOSTARTTHE
FIRE.
• Combustiblematerialsmayignite.
Figure 3.1