Harman® • P-Series Owner’s Manual_R1 • 03/146 3-90-436168c
2
Product Specic and Important Safety Information
A. Appliance Certication
TheP61AandP68FreestandingPelletStovebyHarman®
are exempt from Environmental Protection Agency
certication under 40 CFR 60.531 by denition [Wood
Heater(A)“AirtoFuelRatio].
TheP43isEPAcertiedtocomplywithJuly1990particulate
emissionstandards.
B. Mobile Home Approved
This appliance is approved for mobile home installations
whennotinstalledinasleepingroomandwhenanoutside
combustionairinletisprovided.
Thestructuralintegrityofthemobilehomeoor,ceiling,and
wallsmustbemaintained.Theappliancemustbeproperly
groundedtotheframeofthemobilehomeanduseonlylisted
pelletvent,Class“PL”connectorpipe.
A Harman® OutsideAir Kit must be installed in a mobile
homeinstallation.
NOTE: Thisinstallationmustconformwithlocalcodes.
Intheabsenceoflocalcodesyoumustcomplywiththe
ASTM E 1509-04, ULC/ORD-C1482-M1990, ULC-S627-
00, (UM) 84-HUD
MODEL: P43PelletStove
LABORATORY: OMNITestLaboratories,Inc
REPORT NO. 135-S-23-4,135-S-23b-6.2
TYPE: PelletFueled/SupplementaryFor
ResidentialUse
STANDARD(s): ASTME1509-04,ULC/ORD-
C1482-M1990,ULC-S627-00
MODEL: P61APelletStove
LABORATORY: OMNITestLaboratories,Inc
REPORT NO. 135-S-22-4,135-S-22b-6.2
TYPE: PelletFueled/SupplementaryFor
ResidentialUse
STANDARD(s): ASTME1509-04,ULC/ORD-
C1482-M1990,ULC-S627-00
MODEL: P68PelletStove
LABORATORY: OMNITestLaboratories,Inc
REPORT NO. 135-S-13-2,135-S-13b-2,
135-S-13c-6.2
TYPE: PelletFueled/SupplementaryFor
ResidentialUse
STANDARD(s): ASTME1509-04,ULC/ORD-
C1482-M1990,ULC-S627-00
C. Glass Specications
This appliance is equipped with 5mm mirrored ceramic
glass.Replaceglassonlywith5mmceramicglass.Please
contactyourdealerforreplacementglass.
D. Electrical Rating
120VAC,60Hz,Start4.2Amps,Run2.8Amps
NOTE: Some generator or battery back-up systems may
not be compatible with the micro-processor electronics
on this appliance. Please consult the power supply
manufacturer for compatible systems.
THE STRUCTURAL INTEGRITY OF THE
MANUFACTURED HOME FLOOR, WALL, AND
CEILING/ROOF MUST BE MAINTAINED.
DO NOT INSTALL IN SLEEPING ROOM.
WARNING