Harman P43 - Ignition Cycles

Harman® • P-Series Owner’s Manual_R10 • 2014 - ___ • 11/1513 3-90-436168c
D. Ignition Cycles
1. Atthebeginningofeachignitioncycle,itisnormaltosee
somesmokeintherebox.Thesmokewillstoponcethe
restarts.
2. Thedistributionblowerwillautomaticallyturnonafteryour
appliancehasreachedthesettemperature.
Thisblowertransfersheatfromyourapplianceintothe
room,andwill continuetorunin“constantburn” mode
atthesetspeedyouhavethecontrolknobat.In“room
temp” mode however, the blower will turn on and off
inaccordanceto what temperature theroomsensor is
reading.Whentheroomsensorissatisedtheblowerwill
shutdownuntiltheroomsensorseesademandforheat.
3. Occasionallytheappliancemayrunoutoffuelandshut
itselfdown.Whenthishappens,theunitwillneedtobe
turnedtotheoffpositionandrestarted.
Ifneeded,follow the instructions inSectionA “Starting
YourFirstFire”.
FireRisk
DoNOToperateappliance:
• Withappliancedooropen.
• Burnpotooropen.
• Cleaningslideplatesopen.
DoNOTstorefuel:
• Closerthanrequiredclearancestocombustibles
toappliance
• Within space required for loading or ash
removal.
WARNING
!