EasyManua.ls Logo

Harman P68 - Venting; Vent Pipe; Avoiding Smoke and Odors

Harman P68
33 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9
P68 Pellet Stove
Outside air ex pipe
goes here.
Inlet Cover part#
1-10-08542
Flex pipe part#
1-00-08543 (25')
Outside Air
Here arefourbenetsof outside air:
1. Having air introduced from outside the living area
boostsoverallefciency.
2. It eliminates draft problems that can occur in tight
homes.
3. It reduces smoke spillage in the event of a power
failure.
4. It allows your vent termination to be as close as
18" from windows or doors.
Outside air is optional except in mobile
homes and where building codes require. The
benetofoutsideairismainlynoticedinsmall,very
tight, houses.
To install outside air use 2 3/8" I.D. non-
combustibleexpipe.Thereisabreak-awayhole
on the rear panel of the P68 stove which must be
removedbeforeconnectingtheexpipe.The pipe
should be run outside and terminate to the side or
belowtheventpipeoutletsotheueoutletismore
than 12" from the inlet cover. The maximum length
run of this pipe is 15 feet. If a longer run is needed
the size must be increased to 3". Inlet cover part
number 1-10-08542 should be used to keep birds,
rodents, etc.out of the pipe.
You may choose to use the optional Direct Vent
Wall Passthrough Kit (part #1-00-677077) which
incorporates the venting passthrough and outside
air inlet into one component.
HRV
When installing in a house with a Heat Reclaim-
ing Ventilation System (HRV) be sure the system is
balanced and is not creating a negative pressure in
the house.
Venting
Direct Vent Wall Passthrough Kit
(part #1-00-677077)

Other manuals for Harman P68

Related product manuals