4.3: INPUT CHANNEL > DYNAMICS
Vi3000 USER MANUAL
4.3 INPUT CHANNEL > De Esser
Vi3000 USER MANUAL
15.1 15.1 TALKBACK & OSC > CONTROLS
15.1 TALKBACK & OSC > CONTROLS
15.1: Talkback And Oscillator Controls
Talkback And
Oscillator Set-
up Active
Open and close the
Talkback and Oscil-
lator setup screen in
the master Vistonics
screen.
Open Setup
Screen
Talkback XLR
Connector
The Talkback Mic input.
There is a switch for phantom power adjacent to the
Talkback Mic connector if required.
Talkback / OSC
Level Control
Control of Talkback or
Oscillator level.
For Talkback, the analogue Mic Amp gain is variable
from 46-66dB by an internal variable preset which is
located on the pcb that is located inside on the base
of the console. This is set by default to a mid-range
setting. If the Oscillator is active, the control adjusts the
Osc level to all destinations. The level setting is stored
independently for TB and Osc.
Talkback To
Internal Active
Route the Talkback
signal to pre-selected
output busses.
The 'INT' routed Output busses are selected via their
{TB} VST keys in the VST area of the master screen
after selecting the [TB ASSN] key (located to the right of
the master screen’s VST area). Switch between the two
sets of 16 busses with the [PAGE A] and [PAGE B] keys.
Sends Talk-
back signal to
pre-selected
Aux/Group/
Matrix Busses
To Next Page
Loading...
