Harmonic ProView 7000 - Page 6

How to Configure and Monitor the ProView 7000
© 2010 Harmonic Inc. 6 ProView 7000, v.2.3, Rev. A
6. Select 3InputType, (Options: MPEG and DVB). This also sets the respective PSI/SI tables
for the output stream.
NOTE: The default option for stream type is DVB. For ATSC systems, set the stream type to MPEG.
7. To configure the multiplex output:
iNavigate
Root > 3 Routing and Descrambling > 1 TS (1,2,3 or 4) > 4 Output Selection.
ii Select one or more outputs for the received transport stream (Options: ASI 1, ASI 2,
Socket 1, Socket 2, Socket 3 and Socket 4.) The four sockets are virtual and must be
mapped to a physical MPEGoIP port.
iii Select
Enable in each output sub-menu that you select.
NOTE: In this mode, stream information is not processed and output bit rate is identical to input bit
rate.
iv Navigate Root > 3 Routing and Descrambling > 1 TS 1 (1,2,3 or 4) > 1 Activation.
v Select
1 Enable.
8. To select a program for descrambling:
iNavigate
Root > 3 Routing Descrambling > 1 TS (1,2,3 or 4) > Descrambling.
A list displays of all input programs received.
Program name, program ID, program type and program scrambling state display.
ii Select a program for descrambling.
iii Select CAM Selection.
iv Select CAM 1 or CAM 2 to map the program to it.
Repeat steps 5 to 8 for each multiplex that you wish to use (1, 2, 3 or 4).
9. Navigate
Root > 2 Decoding > 1 Configuration> 2 Input Selection.
10. Select a multiplex, 1,2, 3 or 4, for input.
11. Set the Service Selection Mode:
iNavigate
Root > 2 Decoding > 1 Configuration > 1 Service Selection Mode.
ii Select
2 Program Selection.
Descrambling
1-3-1
1 BBC, ID:4301, TV, CAS
2 CNN, ID:4302, TV, CAS
3 IBA 2 ID:4308, AUDIO, FTA
4 MI-TV, ID:8025, TV, FTA