Harmony 1 - Installing Headboard

11
STEP 5
Carefully flip over your topside-down Adjustable Base. Lift up the Base to desired location.
STEP 6
Plug the AC Main Cable (B) in an electrical outlet with 100-240V, 50/60 Hz. A surge protector
(not included) is recommended for longer life of your Adjustable Base.
STEP 7
Take out Retainer (D) Wrench (G) and remove 4 Bolts For Retainer (H) and 2 Ellipse Plates (I)
from your adjustable base.
Follow the installation instruction in the following picture.
STEP 8 (Installing Headboard)
Raise the Backrest by using Remote Control (A). Take out the Wrench (G), two Bolts (J), four
Washers (L) and two Nuts (K) from the Accessories Box.
IMPORTANT NOTE:
Be Careful when flipping your Base:
The installed legs could get damaged or bent by excessive
pressure, if you lean your Adjustable Base on the legs.
1.
Do not recline the Base against the installed legs to flip it over.
2. Do not drag the Base across the floor.