Harper 5400 - Point Hitch Pins

Chipper/Shredder
R
R
\
CS-5400 PTO Powered Model
PTO Shaft - Transfers power from the tractor
to the Chipper/Shredder. Due to varia-
tions in tractor styles, the operator is
responsible for ensuring that the PTO
shaft is the correct length for a given
tractor. (See the Assembly instruc-
tions.)
3-Point Hitch Pins - Mounts the Chipper/
Shredder to the 3-Point Hitch of the
tractor.
Chipper Chute - Materials to be chipped are
fed into the chipper chute.
Shredder Hopper - Materials to be shredded
are fed into the shredder hopper.
Jackshaft – The jackshaft is connected to
the PTO shaft and used to adjust ten-
sion for drive belts.
Discharge - The area where chipped and
shredded materials are discharged.
SAFETY WARNING!
Make sure that angle of PTO shaft does
not exceed 15 degrees.
CS-1800 18 HP Gas Powered Model
Engine Throttle Lever - The throttle lever
controls engine speed and ranges
from full throttle operation to low idle
for warm up.
Engine Choke Lever - The choke lever is
used in cold starting situations. Refer
to engine manual for starting instruc-
tions.
Key Switch –The key switch is used for
starting the engine.
Fuel Tank – The fuel tank is located on the
hitch and has a 3-gal. capacity. Refer
to engine manual for fuel recommen-
dations.
Make sure vent is open before operation.
Drive Sheaves, Belts, Bearings and
Shields – All are driven from the engine.
(Not shown in photo.)
Trailer Hitch - Tow unit with a 2” ball only.
Always use a safety chain. This unit
it not designed for highway use – 30
MPH max.
Jack Stand – The jack stand should always
be in the up position when transport-
ing. When operating Chipper/ Shred-
der it should be down and locked.
Chipper Chute - Materials to be chipped are
fed into the chipper chute.
Shredder Hopper - Materials to be shredded
are fed into the shredder hopper.
Discharge - The area where chipped and
shredded materials are discharged.
Control Identication
Chipper
Chute
Chipper
Chute
Key
Switch
Jack
Stand
Fuel
Tank
3 pt.
Hitch
Pins
PTO
Shaft
Shredder
Hopper
Shredder
Hopper
Discharge
Discharge
Hitch
8