Harris FALCON III - Page 93

91

Dedicated SATCOM
Programming (3)
PGM – SYS PRESETS – CFG – 06 - VULOS
TX POWER
SQUELCH
TRAFFIC
. . PRESETS – CFG – 06 – VULOS - TRAFFIC
TRAFFIC MODE
TO SCROLL / ENT TO CONT
VOICE
. . PRESETS – CFG – 06 – VULOS - TRAFFIC
VOICE MODE
CVSD
ENT TO CONTINUE / CLR TO EXIT
. . PRESETS – CFG – 06 – VULOS - TRAFFIC
OPTION CODE: 132
25K FSK 16.0K OFF
BW MOD TYPE RATE FEC
. . PRESETS – CFG – 06 – VULOS - COMSEC
ANDVT RX PRIORITY
TO SCROLL / ENT TO CONT
ENABLED
. . PRESETS – CFG – 06 – VULOS - COMSEC
VOICE AUTOSWITCH
TO SCROLL / ENT TO CONT
ENABLED
. . PRESETS – CFG – 06 – VULOS - TRAFFIC
FM DEVIATION
TO SCROLL / ENT TO CONT
8.0 KHz
. . PRESETS – CFG – 06 – VULOS - COMSEC
TRAINING FRAMES
TO SCROLL / ENT TO CONT
20
• If ANDVT was selected for the Crypto Mode there are 3 additional screens.
Training Frames, ANDVT RX Priority, and Voice Autoswitch. TRAINING
FRAMES are the number of redundant data transmissions the radio transmits
before re-establishing the handshake. Valid settings are 6, 9, 12, 15, 20, 30, and
60. All radios in a net need to be set the same.
• ANDVT RX PRIORITY adds a four second transmit inhibit in the absence of the
End Of Message flag. (ENABLE or DISABLE)
• VOICE AUTOSWITCH enabled allows the radio to automatically switch between
MELP and LPC voice modes based on the incoming transmission. (ENABLE or
DISABLE)
• Select TRAFFIC.
• Set TRAFFIC MODE to VOICE. Other choices are VOICE AND DATA, or DATA.
VINSON DATA is 16 kbps.
• VOICE MODE cannot be edited, press ENT
• The OPTION CODE also cannot be edited. 132 is the option code for both Voice
and Data at 16 K.