Tutorial
4 - GAIN
Continuously variable input gain for the 32Classic MS mic preamplifier.
5 – (-20)
Activates a 20dB fixed pad on the mic preamplifier.
6 - 48v
Activates 48-volt phantom power for the 32Classic MS mic preamp. +48V phantom power, required for certain condenser
and active ribbon microphones. Dynamic or Passive Ribbon microphones do not require phantom power to operate and in
some cases can cause damage to the microphone. If in doubt, make sure +48V is disabled before plugging in any
microphone.
7 - LINE (Potentiometer)
Control the input trim +-6dB when the line input is selected as the source for the 32Classic MS source.
8 - LINE (Switch)
Activates the line input as the source for the 32Classic MS unit.
9 - POLARITY (Ø)
Flips the polarity of the selected input source of the 32Classic MS unit. When dealing with multi-mic'd instruments such as
drums, phase cancellations can occur due to the microphones receiving the sound waves at different times. Flipping the
polarity (or phase as it is often referred to) on certain channels can help resolve these cancellations.
10 - SIG (LED)
Bi-colored LED meter for the selected input source of the 32Classic MS unit. Green (present) Yellow (0dB) Red (peak).
11 - INS
Activate the 32Classic MS insert point for inserting other outboard gear for use in conjunction with the 32Classic MS
channel strip.
9 32Classic MS
To Next Page
Loading...