32
7. Adding Fuel / Heating at Nominal Thermal Output
More fuel should be added to the fi re when the fl ames from
the previous burning off phase have just gone out.
Adding Fuel / Heating at Nominal Output
Procedure Position of
Control Elements
Adjust primary and
secondary air.
Close primary air slider
(I), set secondary air
slider (II) to position 2.
Close fi re grate. Push in fi re grate slider.
[a]
Add two logs weighing approx.
2 kg in total. Place logs with
one end to the front of fi re box.
Only add a single layer of fuel.
Open fi re box door
Close fi re box door
Tab. 2
fi g. 4
8. Emptying the Ash Drawer
As a safety precaution, please make sure to wait until the
ashes are cold before you dispose of them. While the ash
collects during the fi re, the lid is located under the ash drawer.
Remove both the ash drawer and the lid located underneath
it. Slide the lid onto the ash drawer so that it is closed; this
prevents ashes from fl ying around, which in turn means your
home stays clean. To place the ash drawer back into the stove,
proceed in the reverse order.
CAUTION!
Piled up ashes can impair or even block the
supply of primary air supply to the stove.
Please ensure that the air supply path for the
primary air between the ash drawer and the
bottom of the ash compartment remains clear.
To Next Page
Loading...
