HASE Sendai - Lighting the Fire

43
7. Lighting the Fire
Thering upphase shouldbe asshort aspossi-
ble, since higher emissions can occur during this
phase.
The slider settings described in Table 1 are rec-
ommendations that were determined under con-
formance testing conditions, in compliance with
the relevant standard. Depending on the weather
conditions and the draught capability of your chim-
ney, accordingly adjust the slider positions for your
Sendai to the local conditions.
NOTE!
The Sendai may only be operated when
the re box door is closed; the re box
door may only be opened to add fuel.
WARNING!
Never use spirits, petrol, or other amma-
ble uids to light the stove.
Lighting the Fire
Procedure Position of Control
Elements
Switch air slider to the
heating-up position.
Pull out the air slider out
completely across the
red mark.
Pile up any remaining ash
and unburned charcoal
into the centre of the
combustion chamber.
Openregrate. Pullregratesliderallthe
way out.
Place 4-6 small pieces of
wood with an approx. Ø
of 3-6 cm and max. 2 kg
in the middle of the burn-
ing chamber. Layer these
cross-wise on top of each
other. Place approx.
0.5 kg of wood shavings
ontopasarelighter.
Light the kindling/ignition
material.
Delhi
Stop the heating phase
as soon as the fuel is
completely ignited.
Push in the air slider
until the red marker is no
longer visible.
Closeregrate. Pushinregrateslider.
Tab. 1
CAUTION!
To prevent adverse effects on health, no-
body should stay in the room(s) during
this process unless absolutely necessary.
Make sure the room is well-ventilated and
open the windows and outside doors. If
needed, use a fan for faster air circula-
tion.
If the maximum temperature is not reached dur-
ingthe rstheatingoperation, youmay noticean
odour for a short period of time the next time the
stove is used as well.