Maintaining the Feeder10.2
Replacing the Feeder Fingers rubber pad
Feeder fingers are located under the Feeder top cover. They press the mail against Feeder
belts, then catch the mail and carry it into the Feeder.
These Feeder fingers have rubber pads in contact with the mail. After a large number of
cycles, they are subject to wear, so that the Feeder cannot catch the mail well. In this case,
you need to replace the rubber pads.
How to Replace the Feeder Fingers
To remove a Feeder Finger rubber pad:
1. Open the Feeder top cover
2. Keep firmly the finger pad from both ends.
326
| Page 326 | Oct-05-2016 11:35 |
10
Maintenance
To Next Page
Loading...
