Viewfinder Signal
This indicator located under the left edge- of the
focusing screen displays two different signals,
both shown
in
a
red
glowing light. The indicator
is only
in
operation when the camera
is
used with
flash adapters SCA 390 or 590 and a flash unit
that conforms
to
the corresponding System SCA
300 or 500.
Ready Signal
A steady red light indicates that the flash unit
is
charged and ready to be fired.
--------
Result Signal
A blinking red light that occurs for just over a
second after exposure indicates that the flash
has emitted the right amount of light for a correct
exposure. After the blinking signal, the indicator
returns to the ready signal when the flash unit is
once again fully recharged.
No
Result Signal
This indicates that the flash emitted was not
sufficient for correct exposure. The aperture
503cx only
1
I
~"'J
rid
h
~
1/
~
~-
I
,
\'
-
-
I
~
o U
0
\ \
I I
L.>
L.>
must then
be
opened or the flash distance to the
subject must be reduced. Changing to a faster
film is also a possibility.
The Ready Signal will appear after a short but
variable length of time depending on the condi-
tion of the batteries.
Please refer
to
your flash unit's operating instruc-
tions for more information about other functions
when using automatic flash light metering that
conforms to System SCA flash photography with
flash sensors, or with non-automatic flash units.
27
To Next Page
Loading...
Need help?
General
