Hasselblad Flextight X5 - Initiating Scan via Software; Scanner Resolutions; True Resolutions Table

lines printed on the holder to line up the image. Handle the clear plastic layer only
by the edges to avoid ngerprints. Curl the plastic layer back and slip the front edge
into Flextight’s foil holder.
9. Lay the top layer of the holder down at over the original.
• For the reective holder, note the four metal pegs (the top two are shown as A and
C in the gure below); make sure that the clear plastic sheet is pressed all the way
down over all four pegs. Note also the two curved tabs at the top of the holder (B in
the gure below); the clear sheet must slip under each of these tabs, as shown.
10. Go to your computer and follow the directions given in the FlexColor software
manual to take a preview, make settings, and take the nal scan. Alternatively you
can press the scan button on the light table. This will initiate a 3F scan according to
your 3F settings.
Resolutions
TrueResolutions
etablebelowshowsthemax.resolutions(inppi)availablewitheachoftheoriginal
holderswhenscanninginTrueResolutionsmode.
Original   Max.resolution(ppi)atfullscanningwidth.
35mmPortrait   8000(FlextightX5)6300(FlextightX1)
35mmLandscape  5000
45x60mmPortrait  4000
60x60-60x70mm  3200
4”x5”Portrait   2040
A4Portrait   960
Table1:TrueResolutions
A B C
10