Form No. TPTM-1107
5
OPERATION
GENERAL
Unit is not waterproof. DO NOT submerge in
water. Do not operate if it has been submerged
in water.
Some exterior surfaces on the unit will get hot.
Use caution when touching these areas to avoid
injury.
In case of fire, disconnect the toaster from its
power source immediately. This allows the unit
to cool, making it easier and safer to put out the
fire.
To prevent any injury or damage to the unit, do
not store or use gasoline or other flammable
vapors or liquids in the vicinity of this or any
other appliance.
To avoid electrical shock, personal injury, or
damage to the unit, do not pick up the toaster by
inserting fingers into the toasting slots and
grasping the heating elements.
To avoid electrical shock, personal injury, or
damage to the unit, never insert a knife, fork, or
similar objects into the toasting chamber.
To avoid damage to the unit or injury to
personnel, always operate toaster with crumb
tray installed.
To avoid any injury, do not remove the crumb
tray for cleaning until the toaster is cool.
The toasting of coated or buttered products
such as garlic bread, cheese sandwiches and
sweet rolls is NOT recommended. Residue will
reduce toaster performance and could possibly
ignite inside the toaster.
TPT series toasters are intended for commercial
use only — NOT for household use.
1. Plug the unit into a properly grounded electrical
outlet of the correct voltage, size, and plug
configuration (see SPECIFICATIONS for
details).
Figure 6. Controls and Crumb Tray
Figure 7. Toaster with Cord Wrap
Operating
Levers
Color Control
Knobs
Toasting
Slots
Crumb Tray
NOTE: The TPT-120 series is equipped with cord
wrap clips on the bottom of the toaster to
minimize clutter. Place excess cord around
cord wrap clips (see Figure 7.).
2. Set COLOR CONTROL knobs to desired toast
darkness. For lighter toast, turn the COLOR
CONTROL knob counter-clockwise. For darker
toast, turn the COLOR CONTROL knob
clockwise (see Figure 6).
3. Place product in toasting slots and push
operating lever(s) down to toast product.
Operating lever(s) will raise at the end of the
toasting cycle automatically.
NOTE: The operating lever(s) can be lifted
manually during toasting for product
removal.
4. For periodic cleaning, remove and empty the
crumb tray.
NOTE: Do not operate the toaster when the crumb
tray is removed.
To Next Page
Loading...
Need help?
General
