Connect the power supply of adequate power, the power cord must be equipped with an earthing
system.
Only use the remote control when the gate is in sight. Do not go under a working gate.
Remote controls should be kept out of the reach of children.
Make sure the door is protected against fire, moisture or strong electromagnetic fields.
At least twice a year, check that the gate is properly balanced, that all mechanical elements are in good
technical condition, and that the chain has the correct tension..
Nothing is displayed on the LED display.
The gate is down.
1. Make sure the power is on
2. Check the fuse and, if necessary, replace
it with a new one (2.5A)
After turning the supply on, the drive
does not carry out the test (the digits
should change from "99" to "11") or
the display shows a different character.
Defective microcontroller
Send the drive to the service with a
description of the fault and the purchase
document
Program the end positions anew in
accordance with the instructions
The selected button on the remote
control cannot be logged in
1. The selected button is used for the
lock function
1. Select a different button for logging in
2. Defective remote control
2. Send the remote control to the service
together with a description of the fault and
the purchase document
After programming the end position,
the actuator is inoperative
1. End positions incorrectly set
1. Re-program the end positions. Please
note that we set the top position first, and
then the bottom position. Neither position
can be set to pressure.
2. The gate lock function has been
activated
- if switching on the blocking function was
accidental, turn this function off
- if switching on the blocking function was
intentional, first press the button
responsible for blocking on the remote
control (button "D"), and then the one that
is logged in.
3. Remote control button for the drive
not logged
3. Log the remote control into the drive
according to the instructions.
The door opens but does not close
1. The photocells support function is
enabled but the photocells are not
installed
1. Disable the photocell operation function
according to the instructions
2. The path of infrared rays has been
interrupted
To Next Page
Loading...
