Hatz 2-4L41C - 7.6 Switching Off the Engine; Engine Shutdown Safety Precautions

Operation and use 2-4L41C, 2-4M41(Z), 4L42C, 4M42
52
HATZ
Manual
Flashing codes
The indicator (5) only flashes during operation if a problem arises in connec-
tion with the exhaust gas return system. This includes a dirty air filter. This
can be identified by the following flash code of the indicator (5):
▪ 7 times short flash (approx. 0.5seconds) and 1 long flash (approx.
1.5seconds).
▪ The flash code indicates that the air filter must be cleaned or changed
(see chapter 8.2.12 Checking and cleaning the air filter cartridge, page
81).
▪ If a different flash code appears, please contact the nearest Hatz service.
NOTICE
i
If the electronics indicate a problem continuously for more than
15 minutes without interruption (flash code - indicator 5), the en-
gine switches off automatically.
▪ If the problem persists, the engine can be started but only
for another 15 minutes.
▪ If necessary, contact your nearest HATZ service station.
7.6 Switching off the engine
Safety notes
CAUTION
Danger of injury from unauthorized access.
There is a danger of injury if unauthorized persons handle the
machine.
▪ Protect the crankhandle and starting key against unautho-
rized access upon breaks in operation or after completing
work.
CAUTION
Danger of engine damage.
▪ Never stop the engine on the decompression lever.
CAUTION
Protect the ignition lock against dirt and moisture.
▪ With the starting key pulled out, seal the ignition lock with
the protective cap.