Maintenance 2-4L41C, 2-4M41(Z), 4L42C, 4M42
70
HATZ
Manual
Procedure — Adding oil
Step Activity
1 Add engine oil to the max. mark on the dipstick(1).
▪ For the specification and viscosity, see chapter 4.4 Engine
oil, page 25.
▪ The code letter on the dipstick (2) indicates whether the en-
gine is equipped with an oil sump or not (see chapter 4
Technical data, page 21).
2 Reinsert the dipstick (1).
3 After a short test run, check the oil level and correct it if neces-
sary (see the chapter 7.9 Check the oil level, page 57).
8.2.6 Checking the poly v belt
Safety notes
CAUTION
Danger of burns.
There is a danger of burns when working on a hot engine.
▪ Let the engine cool before maintenance.
CAUTION
Damage from inadequate engine cooling.
Only operate the engine when all covers are installed.
Preparation
Step Activity
1 On encapsulated engines, unscrew the cover of the air guide
housing (see chapter 5 Engine design, page 27).
1 On engines without a capsule, unscrew the belt guard (see
chapter 5 Engine design, page 27).
To Next Page
Loading...
