Maintenance 2-4L41C, 2-4M41(Z), 4L42C, 4M42
86
HATZ
Manual
Step Activity
4 Mount the cylinder head cover again:
▪ Always renew the gaskets.
▪ Use the fixing nuts for the cylinder head cover no more than
twice before renewing them.
▪ Tightening torque: 10 Nm.
5 Mount all covers.
NOTE:
▪ Under no circumstances is the engine permitted to be oper-
ated if not all covers are mounted.
6 After a brief trial run, check the cylinder head cover for tight-
ness.
8.2.14 Changing the oil filter
Safety note
CAUTION
Danger of burns.
When working on the engine there is a danger of burns from hot
oil.
▪ Wear personal protective equipment (gloves).
▪ Collect the used oil and dispose of it according to local envi-
ronmental regulations.
Overview
1 Oil filter
2 Strap wrench
To Next Page
Loading...
