2G40, 2G40 H EPA CERTIFIED ENGINES
HATZ
83Operator’s Manual
▪ Air temperature of 25° C ( 77° F)
▪ Atmospheric pressure of 100 kPa (14.5 psi)
▪ Relative humidity of 30 %
Operation of the engine at conditions other than above will affect perfor-
mance and exhaust emissions. Normally the equipment manufacturer takes
this into account during the design of the machine and your equipment will
perform within specifications over a wide range of climatic conditions. How-
ever if you must operate your equipment under very unusual climatic condi-
tions, please contact your nearest Hatz distributor for advice.
MAINTENANCE SCHEDULE-EPA-RELATED PARTS
The following minimum intervals are being adopted for adjustment, cleaning,
repair, or replacement of following components:
At 1.500 hours, and 1.500-hours intervals thereafter:
▪ Fuel injector tips (cleaning only)
At 3.000 hours, and 3.000-hours intervals thereafter:
▪ Fuel injector
The exhaust quality of the engines can be influenced by the execution (the
quality of execution) of above described maintenance work.
Therefore, the maintenance work has to be carried out by a qualified work-
shop.
Hatz authorised workshops, for example, are qualified workshops.
Hatz Diesel of America will give you respective addresses, if required.
EMISSION CONTROL SYSTEM AND ADJUSTMENTS.
The emission control system for this engine is DI (Direct Injection) and EM
(Engine Modification).
No adjustments are needed or possible.
EPA EMISSION CONTROL WARRANTY STATEMENT
YOUR WARRANTY RIGHTS AND OBLIGATIONS.
Motorenfabrik Hatz GmbH & Co. KG warrants the emission control system
on your engine for the periods of time listed below provided there has been
no abuse, neglect or improper maintenance of your engine.
Your emission control system includes:
▪ Fuel Injection pump
▪ Injection nozzle
▪ Extra fuel device
▪ Crankcase breather valve assembly
▪ Air cleaner housing
▪ Intake manifold
▪ Exhaust manifold
To Next Page
Loading...
