2427
Make certain that unit is disconnected from power source
before attempting to service or remove any component.
CLEANING
• Keep machine and workshop clean. Do not allow
sawdust to accumulate on band saw.
• Keep wheels clean. Debris on wheels will cause poor
tracking and blade slippage.
• Keep mechanisms and threaded or sliding surfaces
clean and free of foreign particles.
• Operate band saw with a dust collector to minimize
clean up.
LUBRICATION
• The shielded ball bearings are permanently lubricated
and require no further lubrication.
• Small amounts of machine oil can be applied to belt
tension mechanisms and threaded or sliding surfaces.
• Occasionally apply a coat of paste wax to table top to
keep it slick and corrosion free.
BAND SAW REPAIRS
• If power cord is worn or cut in any way, have it replaced.
• Replace any damaged or missing part.
• Use parts list to order parts.
MAINTENANCE
WARNING
To Next Page
Loading...
