Hawk Hawk-i1 - Page 58

54
Guidance and Manufacturer’s Declaration
The infusion pump is intended for use in the electromagnetic environment specified below. The
customer of the user of the Infusion pump should assure that it is used in such an environment.
Emission Test
Conformance
Electromagnetic Environment – Guidance
Radio frequency emission
GB 4824
Group 1
The infusion pump use RF energy only for its
internal function. Therefore, its RF emissions are
very low and are not likely to cause any
interference in nearby electronic equipment.
Radio frequency emission
GB 4824
Class A
The infusion pump is suitable for use in all
establishments, including domestic
establishments and those directly connected to
the public low-voltage power supply network that
supplies buildings used for domestic purposes.
Harmonic emission
GB 17625.1
Not applicable
Voltage fluctuation/Flash
radiation
IEC 61000-3-2
Not applicable
Guidance and Manufacturer’s Declaration-Electromagnetic Immunity
The infusion pump is intended for use in the electromagnetic environment specified below. The
customer or the user of Infusion pump should assure that it is used in such an environment.
Immunity Test
IEC 60601 Test Level
Conformance Level
Electromagnetic
Environment –
Guidance