15
www.coreservice.co.uk
Hotline: +44 01904 947568
Email support@coreservice.co.uk
• Do not overreach and do not cut above shoulder height. This
helps prevent unintended tip contact and enables better control
of the chain saw in unexpected situations.
• Only use replacement bars and chains specified by the
manufacturer. Incorrect replacement guide bars and saw chains
may cause chain breakage and/or kickback.
• Follow the manufacturer’s sharpening and maintenance
instructions for the saw chain. Decreasing the depth gauge
height can lead to increased kickback.
Residual Risks:
Even with the intended use of the appliance there is always a
residual risk, which can not prevented. According to the type and
construction of the appliance the following potential hazards might
apply:
• Contact with exposed saw teeth of the saw chain
(cuttinghazards)
• Access to the rotating saw chain (cutting hazards)
• Unforeseen, abrupt movement of the guide bar (cutting hazards)
• Flung out of parts from the saw chain (Cutting / injection
hazards)
• Flung out of parts of the work piece
• Skin contact with the oil
• Loss of hearing, if no required ear protection used during work
Save These Instructions:
Instructions concerning the proper techniques for basic felling,
limbing, and cross-cutting.
To Next Page
