52
www.coreservice.co.uk
Hotline: +44 01904 947568
Email support@coreservice.co.uk
TROUBLE SHOOTING
Use this section to help you to try and solve any problems you may have:
PROBLEMS POSSIBLE CAUSES REMIDIES
The chain saw does
not start.
Two battery packs are not installed. lnstall two charged battery packs.
Battery problerm (low voltage). Recharge the battery packs. If
recharging is not effective, replace
the battery pack
Main power switch is off. The chain saw is automatically
turned off if it is un-operated for a
certain period. Turn on the main
power switch again.
The saw chain does
not run.
Chain brake activated. Release chain brake.
The molor stops
running after a little
use.
Battery's charge level is low. Recharge the battery packs. If
recharging is not effective, replace
the battery pack.
No oil on the chain. Oil tank is empty. Fill the oil tank.
Oil guide groove is dirty. Clean the groove.
Poor oil delivery. Adjust the amount of oil delivery
with the adjusting screw.
fhe chain saw does not
reach maximum
RPM.
Battery pack is installed improperty. Install the battery packs as
described in this manual.
Battery power is dropping. Recharge the battery packs. If
recharging is not effective, replace
the battery pack.
The drive system does not work
correctly.
Ask the authorized service center
in your region for repair.
The main power
indicator is blinking.
Switch trigger is pulled under an
unoperatable condition.
Pull the switch trigger after the
main power able condition.
Chain does not stop
even the chain brake is
activated:
Stop the machine
immediately!
The brake bandis worn down. Ask the authorized service center
in your region for repair.
To Next Page
Loading...
