45
www.coreservice.co.uk
Hotline: +44 01904 947568
Email support@coreservice.co.uk
CARE AND CLEANING
CAUTION: Always be sure that the tool is switched off and the battery packs are
removed before attempting to perform inspection or maintenance.
CAUTION: Always wear gloves when performing any inspection or maintenance.
NOTICE: Never use gasoline, benzine, thinner, alcohol or the like. Discoloration, deformation or
cracks may result.
Sharpening the saw chain
Sharpen the saw chain when:
• Mealy sawdust is produced when damp wood is cut;
• The chain penetrates the wood with difficulty, even when heavy pressure is applied;
• The cutting edge is obviously damaged;
• The saw pulls to the left or right in the wood. (caused by uneven sharpening of the saw chain or
damage to one side only)
Sharpen the saw chain frequently but a little each time. Two or three strokes with a file are usually
sufficient for routine resharpening. When the saw chain has been resharpened several times, have it
sharpened at our authorised service center.
Sharpening criteria:
WARNING: An excessive distance between the cutting edge and depth gauge increases
the risk of kickback.
1. Cutter length 2. Distance between cutting edge and depth gauge
3. Minimum cutter length (3 mm)
To Next Page
Loading...
