44
www.coreservice.co.uk
Hotline: +44 01904 947568
Email support@coreservice.co.uk
2. Make the back cut a little higher than the base cut of the scarf. The back cut must be exactly
horizontal. Leave approximately 1/10 of the trunk diameter between the back cut and the scarf.
The wood fibers in the uncut trunk portion act as a hinge. Insert wedges into the back cut in time.
WARNING:Do not cut right through the fibers under any circumstances. The tree will
otherwise fall unchecked.
NOTICE: Only plastic or aluminum wedges may be used to keep the back cut open. The use of
iron wedges is prohibited.
Carrying tool
Before carrying the tool, always apply the chain brake and remove the battery packs from the tool.
Then attach the guide bar cover.
15
To Next Page
Loading...
