Hayter H Series User Manual

If the brush has become worn
or damaged it is simple to
replace the whole brush
assembly or individual
Brushes.
To remove the Brush Stock:
1. Remove the Grass Bag
Assembly by lifting it off the
Pivot Brackets.
2. Detach collector from tractor.
3. Locate the 1/4” nut and bolt
at each end of the brush and
undo and remove using a 7/16”
spanner and socket. Keep
safely taking care not to lose
the washers.
4. Now remove the cover
mouldings and free the Brush
Stock.
5. You can now slide off the
Brush Bosses which each hold
three Brushes. Note their
position on the Brush Stock (fig
50A) which must alternate
when you return them.
6. Slide out and replace
individual Brushes where
necessary and then re¬
assemble.
7. When you replace the cover
mouldings note that the holes
to take the spindles are off
centre and are located at the
furthest end of the Brush
Stock.
27

Hayter H Series Specifications

General

Brand	Hayter
Model	H Series
Category	Tractor
Language	English