USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
7
Wireless Bridge Configuration
The HLWLAN will now scan for available access points. Once it has finished, the SSID of all available
access points will be displayed on the screen as shown below. Touching the desired SSID will begin
the connection process. Depending on the security used by the router or access point, you may be
prompted for a password.
If prompted for a password, the keypad will automatically appear. Enter the password and touch the
check mark to move on. The HLWLAN will begin to automatically connect to the selected access
point. Be patient -- this may take a few minutes to complete. Once complete, verify that you have
connected to the home network by making sure that you have an entry next to “Local IP” in Protocol
Properties, as shown below. Note that your Local IP address will likely be different than the one
shown below. If any IP address is shown, the OmniLogic is connected to your home network. If “Not
assigned” is shown, the OmniLogic is not connected to the home network and you should refer to
Troubleshooting.
Use to scroll though available
access points
Use to refresh the list of
available access points
Use to manually configure an
access point that does not
appear in the list
To Next Page
Loading...