6
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Configuration
With the HLWLAN now connected, power up the OmniLogic. Wait about 3-4 minutes for the Om-
niLogic to fully start. Verify that the HLWLAN is being powered and is connected to the OmniLogic
by looking at the PWR and LAN LED indicators on the backside near the ethernet connection. Both
LEDs should be lit.
After verifying that the HLWLAN is powered, it must now be configured to connect to the wireless
home network. From the OmniLogic’s Local Terminal touchscreen, select the “Wifi Bridge” screen
as shown below. Note that this cannot be performed from Remote Terminals.
To Next Page
Loading...