Plumbing the HydraPure Unit
2
After cutting pipes to length, debur all cut pipe to ensure shavings don't plug
critical points internal to the unit. Use PVC solvent cement to glue pipes into the union
sleeve. NOTE the inlet and outlet pipe positions.
2" X 2½" reducer bushings may be used if using 2" pipe.
1
Attach the (2) PVC 2½" union nuts to the
unit. DO NOT OVER TIGHTEN, OVER TIGHTEN-
ING WILL CAUSE THE UNIONS TO BREAK.
5
USE ONLY HAYWARD GENUINE REPLACEMENT PARTSUSE ONLY HAYWARD GENUINE REPLACEMENT PARTS
To Next Page
Loading...
