Hayward Stratum VRS User Manual

PN: ISVR1000 Rev: M
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Pomona, CA Clemmons, NC Nashville, TN
Tel: 908.351.5400 www.haywardpool.com
Model VR1000
OWNERS MANUAL
OPERATION, & PARTS
Basic safety precautions should always be followed, including the following: Failure to follow instructions can cause severe
injury and/or death.
This is the safety-alert symbol. When you see this symbol on your equipment or in this manual, look for one of the
following signal words and be alert to the potential for personal injury.
WARNING warns about hazards that could cause serious personal injury, death or major property damage and if
ignored presents a potential hazard.
CAUTION warns about hazards that will or can cause minor or moderate personal injury and/or property damage
and if ignored presents a potential hazard. It can also make consumers aware of actions that are unpredictable and unsafe.
The NOTICE label indicates special instructions that are important but not related to hazards.
THIS MANUAL CONTAINS IMPORTANT INFORMATION ON THE OPERATION,
AND SAFE USE OF THIS EQUIPMENT.
THIS MANUAL IS INTENDED FOR THE END USER OF THIS PRODUCT.

Hayward Stratum VRS Specifications

General

Brand	Hayward
Model	Stratum VRS
Category	Lighting Equipment
Language	English

Summary

Important Safety Instructions

General Safety Warnings

Covers warnings about children, installation, electrical hazards, and GFCI requirements.

Electrical Safety and Wiring

Details NEC compliance, GFCI protection, and bonding requirements for safe electrical connections.

Suction Entrapment Hazards

Lists and explains various entrapment risks: hair, limb, body, evisceration, mechanical.

System Operation and Safety

Entrapment Prevention and System Safety

Provides warnings on suction outlet maintenance, pressure limits, fire hazards, and installation.

General Information and Installation

Installation and Wiring Guidelines

Emphasizes professional installation, electrical compliance, and system rating.

Electrical Connections and Diagrams

Wiring Diagrams and Configurations

Provides diagrams for internal control, power connections, and three-phase pump motor setup.

User Interface and Error Screens

Error and Exception Screens

Explains error messages like "STOP SWITCH" and "S/S VENT ERROR" with required actions.

System Status and Modes

Vacuum Status Alerts

System Stability and Prime Alerts

Timer Event Configuration

Timer Modes and Settings

Setting Pump and Booster Timers

System Operations and States

Operational Modes Overview

Vacuum Anomaly Detection and Response

Explains the VR1000's response to vacuum anomalies, including shutdown and alarms.

Installation Requirements

Electrical Safety and Specifications

Covers electrical warnings, supply voltage matching, and a chart of motor ratings.

Grounding and Bonding Procedures

Details grounding and bonding requirements according to NEC for electrical safety.

Wiring and Initial Setup

Wiring Regulations and GFCI

Pre-Start Up Checks

Pump Priming Procedure