To Next PageTo Next Page
Need help?Do you have a question about the Hayward Super Pump® VS and is the answer not in the manual?
General| Type | Variable Speed |
|---|---|
| Voltage | 230V |
| Speed Range | 600 - 3450 RPM |
| Energy Efficiency | Energy Star Certified |
| Motor Type | Permanent Magnet, Totally Enclosed Fan Cooled (TEFC) |
| Warranty | 3 Years |
| Control | Digital Control Interface |
| Port Size | 1.5" x 2" |
| Maximum Flow Rate | 90 GPM |
| Model | Super Pump® VS |
Manual covers installation and operation of the Hayward Super Pump Variable Speed Pump.
Lists key features like enclosed motor, advanced hydraulics, programmability, and drive protection.
Provides physical dimensions of the pump in inches.
Guidance on selecting an optimal location for the pump, considering suction lines and environment.
Instructions for securely mounting the pump on a level, rigid base to reduce vibration.
Recommended flow rates and pipe lengths based on pipe size for optimal pump performance.
Details on sealing threaded connections using Teflon tape and avoiding pipe dope for plastic components.
Emphasizes compliance with electrical codes, grounding, bonding, and safe wiring practices.
Lists voltage, amperage, speed range, and branch circuit requirements for the pump.
Explains voltage tolerance and what to do if voltage deviates from the nameplate rating.
Procedures for grounding and bonding the pump to prevent electrical shock hazards.
General wiring precautions, including permanent connection and using the circuit breaker as a switch.
Step-by-step instructions for the physical installation process, including power disconnection.
Illustrates the correct method for connecting field wiring to the terminal block.
Pre-operation checks, including water pressure testing and valve positions.
Steps for filling the strainer and initiating the pump start-up sequence.
Explains the buttons and indicators on the pump's control panel.
Lists the available configuration options and menu structure for the pump controller.
Guides through the initial configuration of the variable speed drive after installation.
Details on accessing and adjusting prime mode timer settings within the configuration menu.
How to temporarily adjust pump speeds using the control panel buttons.
Instructions on how to stop and restart the pump operation using the RUN/STOP button.
Explains how error codes are displayed and the general procedure for resolving them.
Describes how to enter service mode for troubleshooting and testing pump functions.
Procedure to restore the pump's settings to their original factory defaults.
Steps for draining and preparing the pump for storage to prevent freezing damage.
Steps for detaching the motor from the pump housing to access internal components.
How to remove the impeller from the motor shaft for maintenance or replacement.
Procedure for removing the ceramic seat from the seal plate.
Detailed steps for installing the new shaft seal assembly onto the motor shaft and seal plate.
Instructions for reinstalling the impeller and fitting the diffuser back onto the seal plate.
Guide for reattaching the motor assembly to the pump/strainer housing after seal replacement.
Visual illustration of pump components with a corresponding part number list.
Addresses common issues like motor not starting, shutting off, or humming.
Troubleshooting steps for reduced water flow, including clogs and piping issues.
Identifies causes of pump noise, such as air leaks, improper mounting, or bearing issues.
Lists specific error codes, their indications, and general resolution steps.
